DIY Charm Bracelet Kit Tutorial

You are going to LOVE this bracelet!


These are the step by step instructions for my DIY Charm Bracelet Kit.

It is currently for sale in my Etsy shop.

The supplies I used:
2 part epoxy glue- I found this at the local hardware store.
scissors
jewelry tools


First you need to find the design that you want to go on the inside.

I found this old dictionary.

Take a pencil & trace the outside of the bubble top cap.

Carefully cut out the circle.


Now place it on the inside of the pendant circle.

Gently put the epoxy glue around the edges of the bubble top cap on the flat side.

I used a piece of plastic to put it on.

Try not to put it from the tube directly onto the cap, its to messy.
Now you can place your bubble top cap into the circle pendant & hold down for a minute.

Set this off to the side to dry.

Dry for 10 minutes or longer depending on what the directions of your glue say.
Once you know that your pendant is dry you are ready for the next step.

Take your jewelry tools & carefully unbend your jump ring.
Place the pendant circle onto the jump ring.
Then decide where on the bracelet you want the pendant to hang.

Add the bracelet ring to the jump ring with the pendant.

Carefully close the jump ring circle.

Now pat yourself on the back & high five the next person that you see.

You just completed your very own DIY Charm Bracelet Kit.

Wear it, love it, & be proud that you made it!
This Imagine Bracelet and lots of other fun accessories are available in my Etsy shop.